LOCATOR® Tool - Core Tool (Male Removal End)

Used to remove the nylon male from the metal denture cap
The sharp circular edge of the removal tool should be wedged tightly down into the very bottom of the plastic male so that it will catch the inside of the plastic insert and pull it at an angle out of the metal housing
Prior to use, loosen the tip a full 3 turns counter clockwise (you will see a visible gap)
To discard the nylon male from the tip of the Core Tool; point the tool down and away from you and tighten the Male Removal Tool clockwise back onto the Core Tool
This will activate the removal pin and dislodge the nylon male from the tip end

LOCATOR® Core Tool (Male Removal End)